Products
Sheet & Post Trailer
Multitasker Dry Van
Galvanized Components
Front coupler – tub crossmembr assy – landing gear frame – upper subframe slider rail assy – rear frame – rear impact guard are all hot dipped galvanized to increase life cycle of trailer by eliminating premature corrosion
Sidewall Structure/Protection
14 ga. X ½” deep x 6 ½” width steel galvanized logistic posts mounted on 16” centers throughout with extruded upper and lower rails & snap-in impact resistant plastic liner & 12” high 18 ga. Galvanized steel for lower interior protection.
Front Wall Designed
(5) full 16 ga. Steel galvanized hat section posts with two .050 pre-painted white aluminum panels eliminating an extra panel lap and a full corner radius corner extrusion and capped with an aluminum corner casting featuring one of the stongest front walls in the industry.
Rear Frame Structure
Utilizes a 7ga x 2 x 4 rectangle structural tube post and header – with a high strength rear sill with full length weld to a ½” x 6” full width bottom bar and ½”x 6” upper corner angle reinforcements stabilizing the header and posts for anti rear frame racking feature.
Specifications
Dimensions
53’ 0” O.A. Length 13’ 6” O.A. Height
110.00 I.S. Height 102.36” O.A. Width
101.00” I.S. Width 52’ 6 5/8” I.S. Length
GVWR: 68,000 lbs. GAWR: (2) @ 20,000 lbs.
Sidewall
- 14 ga. X ½” deep x 6 ½” wide galvanized steel logistic post mounted on 16” centers thruout
- .050 pre-painted white aluminum panels
- Extruded upper and lower rail with (10) ¼” diameter solid aluinum rivets attached to post with 3/16” diametr solid aluminum rivets attached to panel
- 18 ga x 12” high galvanized corrugated steel scuff
Rear Frame
- Structural steel rectangle tube for post and header
- Rear sill with ½” bottom bar and 3/8” light protector
- ½” post protectors at top and bottom
- ½” structural steel corner angles at top
- Bolt-on rear impact guard
- 13 mm composite door panels with dual lockrods
- (4) aluminum hinges per door
Front Wall
- (5) 16 ga. steel hat post – 80 k galvanized
- (2) .050 aluminum pp white panels
- Full one-piece aluminum extruded upper rail
- Stainless steel lower mounting plate
- Extruded aluminum corners
- Aluminum top corner casting
Landing Gear
(6) XMBR mount with bolt on wing plate & Bolt on k-bracing
Lights & Wiring
All led lights with sealed harness
Roof
- One piece .040 aluminum panel attached
- Full perimeter with retainer plate
- Anti-snag 18 ga. Galvanized steel roof
- Bows on 24” centers – bonded to panel
Suspension
- Mechanical spring or air ride – 49” axle spacing – “p” spindles – 2s/1m abs – 30-30 brake chambers
- 5 ½” auto slack adjuster – hub piloted w/ cast drum – steel pp white disc wheels
All designs are subject to change. Please contact a Fruehauf dealer for updated information.